Warning
Stillink x100 systems should be installed and serviced only by qualified personnel who has the necessary training about electrical equipment, and who understands the hazards that can arise when working on this type of equipment.
Finding Suitable Place for Installation
The installation site should be bright enough for ease of operation to the maintenance personnel. The site should have enough space. The system should be installed in a room where there is not too much occupancy. Finding a quite location for the operators IP telephone will reduce occupational strain on the working operator. The 220 VAC mains should not be interrupted except for power outages. The ambient environmental conditions should be within the range of:
- Temperature range: 0-40
- Humidity range: %0-85 (non-condensing)
Ensure that the installation site does not contain:
- High voltage lines, smoke, dust, gas or radiation (such as a generator, photocopier etc.)
- Radio equipment that generates or emits high level signals
- Sever, pipes, or valves that could leak or cause condensation
- Vibration causing equipment
- Exposure heat sources or direct sunlight
Power
Input and output power specifications for the Stillink x100 are:
- Input: 180 - 240 VAC
- Output:5 VDC (1 Amp)
Be aware that AC-DC power adapter is specially designed for the Stillink x100. Never use any adapter or power converter except the one supplied by Telesis. Otherwise, you may damage your system.
Be aware
 | This system should be installed and serviced only by qualified personnel who has the necessary training about electrical equipment, and who understands the hazards that can arise when working on this type of equipment. |
 | External lines or outside lines that could be exposed to environmental conditions should be protected with secondary protective circuitry. |
 | To minimize the risk of electrostatic damage to the system, serviceman should discharge of electrostatic buildup by wearing a shielded bracelet or take other necessary before handling electrostatic sensitive parts such as cards. |
 | This system is to be used in controlled environments where humidity and ambient temperature is maintained within working specifications and necessary precautions should be taken before leaving the equipment un-attendant. |
 | Disconnect all power sources from the system before servicing. |
 | Do not remove or install cards to the system when it is powered up. |
| Attach all covers in place after servicing system and before leaving the customer premises to avoid customer contact with damageable components. |
| Any auxiliary equipment that is connected to the system should be set up according to its installation guide. |
